Leica LS10 - Mode Settings

Field Description
Auto-Off Enable The instrument switches off after
20 minutes without any activity.
Disable The automatic switch-off function is deactiv-
ated.
☞
Battery discharges quicker.
Standby The instrument switches to standby mode
after 5 minutes without any activity.
Beep The beep is an acoustic signal and is used in the following
three variations:
Single beep: sounds as input conrmation after a key
stroke or a touch screen event.
Triple beep: sounds when an error message is displayed or
when a function is not allowed.
Long beep: sounds after a measurement has been stored.
You can set the volume of the beep.
Normal Normal volume.
Loud Increased volume.
Off Beep is deactivated.
Screensaver after 1 min,
after 2 min,
after 5 min,
after 10 min
The screensaver is activated and starts after
the selected time.
Off The screensaver is deactivated.
6.5 Mode Settings
In the Mode Settings screen you can select different measurement modes
for single or multiple measurements.
Multiple measurements: The instrument automatically carries out several
measurements in sequence until one of the following criteria is met:
•
The dened number of measurements is reached.
•
A terminating criterion is met.
•
The procedure is terminated.
For all multiple measurement modes, the instrument stores the average meas-
urement values according to the mean or median selection and all individual
measurements contributing to this average.
1.
Select Settings from the Main Menu.
2.
Select Mode from the Settings Menu.
☞
To quickly access the Mode Settings screen from within a program,
tap on the status icon .
Description
Access
Settings 43