Leica LS10 - Working with a USB Memory Stick

13.4 Working with a USB Memory Stick
1
1
2a
2
010758_001
1. Open the battery compartment by pressing the push button under-
neath the battery compartment.
☞
The USB host port is located at the left side of the battery
compartment.
2. Insert the USB memory stick into the USB host port.
Always return to the Main Menu before removing the USB memory stick. If
you remove the stick without returning to the Main Menu, a warning message
is displayed.
Whilst other USB memory sticks may be used, Leica Geosystems recommends
Leica industrial grade USB memory sticks and cannot be held responsible for
data loss or any other error that may occur when using a non-Leica USB
memory stick.
•
Keep the USB memory stick dry.
•
Use it only within the specied temperature range, -40°C to +85°C (-40°F
to +185°F).
•
Protect the USB memory stick from direct impacts.
Failure to follow these instructions could result in data loss and/or permanent
damage to the USB memory stick.
If you use a completely new USB memory stick or if you want to delete all
existing data, format the USB memory stick before starting to store data.
If the instrument detects a non-recommended File Allocation Table (FAT) on
the USB stick, you are automatically prompted to format the USB stick upon
insertion. The recommended FAT is FAT32. Follow the on-screen instructions
to format with FAT32.
☞
Despite an automatic defragmentation, the USB memory stick gets
fragmented after a while. Format the USB memory stick periodically
to maintain instrument performance.
1.
Select Manage from the Main Menu.
2.
Select
USB stick from the Manage Menu.
3. Press Format in the USB File Manager screen.
Insert a USB memory
stick step-by-step
☞
☞
☞
Format a USB memory
stick step-by-step
94 Data Management