Safety Instructions
9
• There is the risk of injury from pinch and shear points in the three-point linkage
area!
• When operating the external lift controls for the three-point linkage, do not
stand between the tractor and implement!
• Always ensure sufficient lateral limitation for the three-point linkage of the trac-
tor in the transport position of the implement!
• When driving on roads with the implement raised, the raise/lower control must
be locked to prevent lowering!
Hydraulic Equipment
• The hydraulic pipes are under pressure!
• When connecting hydraulic rams, the pipes must be connected as directed!
• Always release hydraulic pressure from both tractor and implement before
coupling!
• When connecting hydraulic pipes to the tractor ensure that incorrect use is
avoided. If the connections are reversed, the opposite function is carried out
(e.g. raising/lowering) and there is a risk of accidents!
• Regularly check the hydraulic pipes and replace them in the event of damage
or signs of ageing. The replacement pipes must comply with the technical
specification as laid down by Lemken!
• When searching for leaks appropriate aids should be used because of the dan-
ger of injury!
• Hydraulic oil escaping at high pressure can penetrate the skin and cause seri-
ous injury! When injured see a doctor immediately! Danger of infection!
• Before working on any hydraulic equipment - lower all implements/attachments,
release hydraulic pressure where possible and switch off the tractor engine!
To Next Page
Loading...
