Index
100 Lenze · E84AYCER communication module (PROFINET) · EDS84AYCER EN 3.0 - 02/2019
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Internal error (error message) 82, 84
Invalid module configuration (error message) 83
Invalid Parameter Set (error message) 82
IP address error (error message) 84
Memory
No access (error message)
81
Read error (error message) 81
Write error (error message) 81
Record parameter
Invalid read (error message)
83
Invalid write (error message) 83
Restart by watchdog reset (error message) 82
Stack init error (error message) 84
Station name error (error message) 83
PROFINET configurator of the »Engineer« 40
PROFINET connection 29
PROFINET error messages (short overview) 80
Protection against uncontrolled restart 46
Protection of persons 12
Protective insulation 17
Protocol data 20
R
Reaction time delay (C13881) 92
Reading parameters from the inverter 57
Residual hazards 12
Runtime delays 21
S
Safety instructions 11
Safety instructions (representation) 10
Setting the IP configuration 39
Setting the station name 37
Settings (C13860) 89
Station name (C13899) 93
Status displays (LEDs) 73
Status displays at X256 and X257 76
Structure of the Ethernet cable 31
Structure of the PROFINET data frame 56
Subnet Mask 43
Subnetwork mask (C13001) 86
Suppress signalling diag. mess. upon (C13887) 93
Switch latency 16, 21
Switching method 16
System error messages 80
T
Table of attributes 96
Target group 6
TCP port 16
Technical data 16
Terminals 34
Terminology used 9
Terms 9
Type of node 16
U
Use of repeaters 28
User data assignment 56
User data length 36
Using the communication module 13
V
Validity of the documentation 6
Voltage supply 16, 33
W
Wiring according to EMC guidelines 27
Writing parameters to the inverter 62
X
XML file for configuration 36
To Next Page
Loading...
