5 When the display shows the following icon, close tray 1.
Note: If tray 1 is not closed, then the printer will boot normally.
6 A screen with red selection items appears.
Tou ch ‑> to navigate to Recovery mode.
7 To uc h Boot or RECOVERY.
Accessing restore point
Note: This functionality is available for 4.3”, 7” and 10” display printers only.
This functionality allows the printer firmware to roll back to a previous state whenever a firmware update causes
problems in the printer.
Notes:
• A restore point is generated when a new firmware code is flashed. Only one restore point is saved.
• If the printer is new, then there are no existing restore points and the key sequence is ignored.
1 Turn
o
the printer.
2 Press and hold the 7 and 8 buttons simultaneously.
3 Turn on the printer.
4 Release the buttons when a splash screen appears.
Accessing the Network SE menu
This menu contains settings for fine tuning the communication settings for the network interfaces and protocols.
1 Navigate to:
Networks/Ports > Standard Network > Standard Network Setup.
2 Press and hold 6, 7, and 9 simultaneously.
4514-6xx
Service menus
201
To Next Page
Loading...
