Lexmark M3150 - Page 91

Error code Description Action
200.24 Measured gap at input sensor too small to meet
video delivery requirements. (Not enough time
since prior image
finished
to start new image).
Go to
“Sensor (input) image jam service check”
on page 94.
200.25 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.29 Printhead drive control out of range due to an
external event beyond what the control is
designed to handle.
Go to
“Sensor (input) image jam service check”
on page 94.
200.30 Invalid printhead NVRAM. Go to
“Sensor (input) image jam service check”
on page 94.
200.31 Paper, in the middle of a job, at input sensor before
interrupt occurred.
Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.32 Detected cover switch bounce. Go to
“Sensor (input) early/late arriving service
check” on page 92.
Printhead lost HSYNCs due to a glitch with the
laser safety interlock, for example, bouncy cover
switch.
Go to
“Laser scanning unit (LSU) service check”
on page 136.
200.33 Input sensor covered too quickly. Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.35 Input sensor covered too long. Source = [x]. Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.38 Interpage servo gap smaller than expected for
galvo oset target evaluation.
Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.42 Rogue sheet at ACM sensor while flushing the
paper path prior to declaring tray 1 source empty.
Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.44 Page from tray 1 did not reach the input sensor (or
the manual feed sensor, if present) after multiple
pick attempts. Page did make it out of the tray at
least as far as the ACM sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 92.
200.84 Image data did not start on time. Go to
“Sensor (input) image jam service check”
on page 94.
200.87 During warm up flush, sheet detected too long
over input sensor.
Go to
“Sensor (input) early/late arriving service
check” on page 92.
4514-6xx
Diagnostics and troubleshooting
91