Lexmark MS823 Service Manual

HCOE upper interface cable removal
1 Remove the HCOE sensor cover. See “HCOE sensor cover removal” on page 547.
2 Remove the HCOE left cover. See “HCOE left cover removal” on page 550.
3 Disconnect the upper interface cable from the controller board.
4 Crimp both connector pins using pliers to make them fit through the pin holes. Push the connector out of
its slot.
5 Remove the upper interface cable.
HCOE latch removal
1 Remove the HCOE left cover or HCOE right cover. See “HCOE left cover removal” on page 550 or “HCOE
right cover removal” on page 549.
2 Pull the latches o the expander, and then remove.
Note: The latch on the opposite side can be removed using the same method shown.
4064
Parts removal
554

Lexmark MS823 Specifications

General

Print Technology	Monochrome Laser
Print Speed	Up to 65 ppm
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 300, 000 pages
Recommended Monthly Page Volume	5, 000 - 75, 000 pages
Processor Speed	1 GHz
Standard Memory	512 MB
Connectivity	USB, Ethernet
Standard Input Capacity	650 pages
Maximum Paper Input	4, 400 sheets
Media Types Supported	Plain paper, Card stock, Envelopes, Labels, Transparencies
Operating System Compatibility	Windows, Linux
Duplex Printing	Automatic