MX32x32DVI-HDCP-Pro and HDMI-Pro
User’s Manual v1.0
Page 15/ 109
2.5.4. MX-OPT-HDMI-IB
Status LEDs Optical connectors Card active LED
(can be ordered with with NT, LC, ST or SC connectors)
This 8-channel optical input card is fully compatible with the HDMI 1.3 and HDCP
1.3 standard. This card uses Lightware’s Single Fiber Technology, which
eliminates the need for additional copper cables. Only one multimode fiber cable is
used per one DVI signal. Single fiber technology lowers the system infrastructure
cost and isolates sources and receivers from ground loops and hum noises.
Main features:
Connectors 8x LC or 8x SC or 8x ST or 8x Neutrik NO2-4FD type
Max. cable length 2600 meters at 1080p
Cable type 50/125 multimode fiber
HDMI HDMI 1.3 compliant
Up to 225MHz pixel clock
16, 24, 30 and 36 bits/pixel are supported
RGB, YUV 4:4:4 and YUV 4:2:2 modes
Audio PCM (up to 192kHz and 8 channel), Dolby, DTS, MLP,
Dolby True-HD and DTS-HD Master Audio support
HDCP HDCP 1.3 compliant
There are four status LEDs next to every input, which indicate the following (from
bottom to top):
LASER detect It illuminates green when laser beam is detected.
SCDT It illuminates green when pixel clock is detected.
HDMI If this LED illuminates, the incoming signal is HDMI. If it
does not illuminate then the incoming signal is DVI.
HDCP It illuminates red when the incoming signal is content
protected and HDCP encrypted.
This card is compatible with the following Lightware products:
HDMI-OPT-TX300
MX-HDMI-OPT-OB (see 2.6.4.)
DVI-OPT-TX100 (DVI signals only, HDCP is not supported)
DVI-OPT-TX200 (DVI signals only, HDCP is not supported)
MX-DVI-OPT-OB-NT card (DVI signals only, HDCP is not supported)
MX-DVI-OPT-OB-R-LC card (DVI signals only, HDCP is not supported)
For further details on these devices, please visit the http://www.lightware.eu
webpage.
To Next Page
Loading...
Need help?
General