MX32x32DVI-HDCP-Pro and HDMI-Pro
User’s Manual v1.0
Page 19/ 109
2.6.4. MX-OPT-HDMI-OB
Status LEDs Optical connectors Card active LED
(Can be ordered with NT, LC, ST or SC connectors)
This 8-channel optical output card is fully compatible with the HDMI 1.3 and HDCP
1.3 standards. This card uses Lightware’s Single Fiber Technology, which
eliminates the need for additional copper cables.
Main features:
Connectors 8x LC or 8x SC or 8x ST or 8x Neutrik NO2-4FD type
Cable type 50/125 multimode fiber
HDMI HDMI 1.3 compliant
Up to 225MHz pixel clock
16, 24, 30 and 36 bits/pixel are supported
RGB, YUV 4:4:4 and YUV 4:2:2 modes
PCM (up to 192kHz and 8 channels), Dolby, DTS, MLP,
Dolby True-HD and DTS-HD Master Audio support
HDCP HDCP 1.3 compliant
There are four status LEDs next to every input, which indicate the following (from
bottom to top):
LED0 Reserved
HDMI It illuminates green when the port operates in HDMI
mode
HDCP It illuminates green when HDCP encryption is active.
LASER active It illuminates red when laser beam is detected.
This card is compatible with the following Lightware products:
HDMI-OPT-RX300
MX-HDMI-OPT-IB (see 1.1.1.)
DVI-OPT-RX100 (DVI signals only, HDCP is not supported)
DVI-OPT-RX200 (DVI signals only, HDCP is not supported)
MX-DVI-OPT-IB-NT card (DVI signals only, HDCP is not supported)
MX-DVI-OPT-IB-R-LC card (DVI signals only, HDCP is not supported)
To Next Page
Loading...
Need help?
General