Page 18 / 109
2.6.3. MX-HDMI-TP-OB
12V DC power RJ45 connectors (Video and DDC) Card active LED
This 8-channel HDMI 1.3 compatible output card is equipped with two RJ45
connectors per each port.
Connectors 8x 2 RJ45 connectors
Signal reclocking Yes
DVI support Up to 165MHz pixel clock, single link only
HDMI support Up to 225MHz pixel clock, HDMI 1.3 compatible
HDCP HDCP 1.3 compliant
Signal monitoring Same as described at MX-DVI-HDCP-IB.
Conversions Same as described at MX-DVI-HDCP-OB.
RS-232 This card can be ordered with an optional RS-232 add-on
card. Each port has an RS-232 connection, where the RX
and TX lines are connected to the RJ45 connectors.
S/PDIF It is possible to transmit the audio signal from the S/PDIF
connector instead of the RS-232 signal over the cable. It
is also possible to transmit the audio signal extracted
from the incoming HDMI signal. These settings can be
done by setting a jumper on the card.
This card is compatible with the following Lightware products:
DVI-HDCP-TP-RX100
HDMI-HDCP-TP-RX100
MX-HDMI-TP-IB (see 2.5.3)
DVI-TP-RX100 (DVI signals only, HDCP is not supported)
MX-DVI-TP-IB card (DVI signals only, HDCP is not supported)
For further details on these devices, please visit the http://www.lightware.eu
webpage.
To Next Page
Loading...
Need help?
General