Joint Robot Manipulator - Software Operation Manual
Advantech LNC Technology Co., Ltd.
73
Record
Similar to the recording of the
program page, put some commonly
used instructions on the right side,
move to the point, click the
command button of Record, it can
automatically bring in the code.
16. NC execution
This page can be used to run the machining path files (GM code) generated by CAM, or the files
exported by the program page, or the files edited manually by the user. These files must conform
to the G code format requirements of this robot system. For detailed G code and program syntax,
please refer to the last two sections.
Switch path
number
Select the files to run
mode
coordinate
button to
switch the
displayed
coordinate
type
To Next Page
Loading...
Need help?
General
