27
Getting Started
English
3. Tap Camera Settings. Enter the admin username and password. By default, the
admin username is admin and the password is left blank. Tap OK.
4. Tap Network then WiFi Network.
5. Check the WiFi checkbox
. The camera will scan for available networks.
Check WiFi
Tap the name of your WiFi
network
6. Tap the name of your WiFi network, enter the password, then tap OK. Wait for the
update to complete.
7. Remove the Ethernet cable from the camera. It will connect to the WiFi network.
When it is c
o
nnected, the blue Network LED will be on or flashing.
8. Press Camer
a
Settings then Camera List to exit the edit camera screen.
9. Tap the camera in the Camera List to connect. If you cannot connect, check to make
sure
you have entered the correct wireless password and that the camera is in signal
range of your wireless router.
To Next Page
Loading...
