Lorex LNR600 Series User Manual

Connecting a PTZ Camera (LNR600 Series)
19
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Begin.
5. Move the camera into the desired end position and click End.
To run a pattern:
• Under No., select the number of the pattern you would like to go to and click
.
19.2.4 Auto Scan
An auto scan automatically cycles between a left and right point.
To create a new auto scan:
1. Click
to open the PAN/TILT/ZOOM menu.
2. Click the Border tab.
3. Move the camera into the desired left position and click Left.
4. Move the camera into the desired right position and click Right.
To run an auto scan:
• Click
.
#LX400078; r.36882/36882; en-US
144

Lorex LNR600 Series Specifications

General

Brand	Lorex
Model	LNR600 Series
Category	Network Hardware
Language	English