Using the Main Menu14
4. Click OK to save settings.
If you want to use your own email server (advanced):
1. Configure the following:
• SMTP Server: Enter the SMTP server address.
• Port: Enter the port used by the SMTP server.
• Anonymous: Check if your server supports anonymous log ins. Otherwise, leave
this unchecked.
• User: Enter the SMTP user name.
• Password: Enter the SMTP password.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender’s email address.
• Subject: Enter the subject line for the email alert.
• Attachment: Check to include a jpg image attachment of the camera.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive
attachments. For details, see 14.3.8 Configuring Motion Detection, page 57.
• Encrypt Type: Select SSL or TLS if your server uses encryption. Select None if
your server does not use encryption.
• Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Health check emails will be
sent periodically to ensure that the system is functioning normally. Also, enter the in-
terval in minutes for health check emails.
2. Click Test to send a test email.
3. Click OK to save settings.
14.3.6 Configuring Switch Settings (Advanced)
You can configure the networking settings for the internal PoE switch.
CAUTION
It is recommended to leave this menu on the default settings. Changing the information in this menu may
disrupt the connection to the cameras.
To configure switch settings:
1. From live view, right-click and select Main Menu.
2. Click
>Network>Switch .
#LX400078; r.36882/36882; en-US
56
To Next Page
Loading...
Need help?
General
