LTS LTD8516K-ST - Configure Email Linkage; Trigger Alarm Output; Configure PTZ Linkage

Network Video Recorder User Manual
109
Step 4 Select the Notify Surveillance Center.
11.2.4 Configure Email Linkage
Purpose:
The system can send an email with alarm information to a user or users when an alarm is
detected.
Please refer to Chapter 15.7 Configure Email for details of Email configuration.
Step 1 Go to System>Network>Advanced.
Step 2 Configure the Email settings.
Step 3 Go to the Linkage Action interface of the alarm detection (e.g., motion detection,
video tampering, face detection, etc.).
Step 4 Select the Send Email alarm linkage action.
11.2.5 Trigger Alarm Output
Purpose:
The alarm output can be triggered by the alarm input, motion detection, video tampering
detection, face detection, line crossing detection, and all other events.
Step 1 Go to the Linkage Action interface of the alarm input or event detection (e.g., motion
detection, face detection, line crossing detection, intrusion detection, etc.).
Step 2 Click the Trigger Alarm Output tab.
Step 3 Select the alarm output (s) to trigger.
Step 1 Go to System> Event>Normal Event>Alarm Output.
Step 2 Select an alarm output item from the list.
Refer to Chapter 11.6.3 Configure Alarm Output for the alarm output settings.
11.2.6 Configure PTZ Linkage
Purpose:
The system can trigger the PTZ actions (e.g., call preset/patrol/pattern) when the alarm event, or
VCA detection events occur.
Make sure the PTZ or speed dome connected supports PTZ linkage.