Network Video Recorder User Manual
8
Supports cloud storage;
S.M.A.R.T. and bad sector detection;
HDD sleeping function;
HDD property: redundancy, read-only, read/write (R/W);
HDD group management;
HDD quota management; different capacity can be assigned to different channels.
For LTD84XXK-ST/ LTD92XXK-ST series, hot-swappable HDD supporting RAID0, RAID1, RAID5,
RAID 6 and RAID10 storage scheme, and can be enabled and disabled on your demand. And 16
arrays can be configured.
Recording, Capture and Playback
Capture is supported by LTD84XXK-ST/ LTD92XXK-ST series DVR only.
Holiday recording schedule configuration;
Cycle and non-cycle recording modes;
Normal and event video encoding parameters;
Multiple recording types: manual, continuous, alarm, motion, motion | alarm, motion & alarm
and event;
The device will note that the exported AVI video may have problems if the frame rates of the
continuous and event recording are different;
Supports POS triggered recording for LTD84XXK-EA /LTD84XXK-ST/ LTD92XXK-ST series DVR;
8 recording time periods with separated recording types;
Supports Channel-Zero encoding;
Main stream and sub-stream configurable for simultaneous recording;
Pre-record and post-record for motion detection triggered recording, and pre-record time for
schedule and manual recording;
Searching record files and captured pictures by events (alarm input/motion detection);
Customization of tags, searching and playing back by tags;
Locking and unlocking of record files;
Local redundant recording and capture;
When Turbo HD, AHD, or HDCVI input is connected, the information including the resolution
and frame rate will be overlaid on the bottom right corner of the live view for 5 seconds.
When CVBS input is connected, the information such as NTSC or PAL will be overlaid on the
bottom right corner of the live view for 5 seconds.
Searching and playing back record files by camera number, recording type, start time, end time,
etc.;
Smart playback to go through less effective information;