20. Enter 6 for Access Services.
Response: The Access Server Commands menu is displayed.
21. Enter 5 for Async service.
Response: The Async Service Names menu is displayed.
22. At the Async Service Names menu, enter the following information: (Use the
<Tab> and <cursor> keys to navigate the menu.)
• At service type, enter X.25–In (Use the return key to change.)
• At X.121 address, enter (3+node number— 1) * 1000 + port # For
example, (3+2–1) * 1000 + 102 is 4102
Note: To identify the node number, identify the order in which the DRMs
were added to the network. For example if the DRMs are sequentially added,
DRM 1 is node 1, DRM 2 is node 2, and so on.
• At X.3 Profile, enter 85.
• At Socket Number, enter (3+node#—1)*1000 + port #.
• At IP address, enter the Ethernet IP address of the router at the DRM site.
For example, 10.10.9.254
23. Press the left arrow key twice.
Response: Cursor is displayed at Process selections (Y/N).
24. Enter Y.
Response: The Async Service Names menu is displayed.
25. To save to flash, enter <ctrl>w
Response: The settings are saved to memory.
26. Press <Esc> until the main menu appears.
Response: The main menu is displayed.
27. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.7
Issue 3.00 Page 3.7-7
To Next Page
Loading...
Need help?
General