3.8.1.2 Assign the High Speed Port on the Router at the DRM site
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 2 for port.
Response: The Configure Port menu is displayed.
3. Enter 2 for Quad-Card.
Response: The Configure Port menu is displayed.
4. Enter 203
Response: The PPP Synchronous Port Configuration menu is displayed.
5. At Port type, enter X.25 line. (Use the return key to change.)
Response: The X.25 Port Configuration menu is displayed.
6. At the x.25 Port Configuration Screen, enter the following information: (Use the
arrow keys to navigate the screen)
• At Port name, enter SCC
• At Connection Mode, enter DCE (Use the return key to change.)
• At Line Speed, enter 9.6 Kbps (Use the return key to change.)
• At X.25 mode, enter DCE (Use the return key to change.)
• At Max Packet size, enter 256 (Use the return key to change.)
• At IPX Routing, enter N (Use the return key to change.)
• At Ethernet Routing, enter N (Use the return key to change.)
• At Permanent/Number of VCs, enter 7
7. Press the left arrow twice.
Response: The cursor is positioned at Process Selections (Y/N).
8. Enter Y
Response: The Configure Port menu is displayed.
9. To save to flash, Enter : <ctrl>w
10. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
3.8.1.3 Assign XOT and define the remote IP Address, port and LCN
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 10 for X.25.
Response: The X.25 Parameters menu is displayed.
3. Enter 5 for XOT switching table.
Response: The XOT PVC SCV Switching Table is displayed.
NETWORK PROCEDURES
Procedure 3.8
235-200-150
January 2003
Page 3.8-2 Issue 3.00
To Next Page
Loading...