4. For each of the 7 LCNs, enter the following information: (Use the arrow keys to
navigate the screen)
• At Service, enter PVC/XOT (Use the return key to change.)
• At LOCAL PORT #, enter 203
• At LOCAL LCN #, enter 1, 2, 3, 4, 5, 6,or7
• At REMOTE PORT #, enter the port number for the OS Router that handles
SCC traffic.
• At REMOTE LCN #, enter 1, 2, 3, 4, 5, 6,or7
• At REMOTE IP Address, enter the IP Address for the OS Router that handles
SCC traffic
5. Press the left arrow key twice.
Response: The cursor is positioned at Process Selections (Y/N).
6. Enter Y.
7. Hold down the Ctrl key and press the W key.
8. Hold down the Ctrl key and press the ] key.
9. Enter quit
3.8.2 At the Host Site, Connect the OSS Router to the Router at the DRM Site
3.8.2.1 Connect the SCC Router at the DRM Site to the OSS Router
Note: If the remote OS router is not to be used to set up a permanent connection for
IP routing from a router at the DRM site, use local procedures instead of the following
procedure to set up the permanent connection for IP routing between the remote
router and the OS router.
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 2 for port.
Response: The Configure Port menu is displayed.
3. Enter the port number to which you wish to connect.
Note: The last number of the port number is the slot number on the back of the
DynaStar. If you want to connect to port 2, choose the port number that ends
with 2. For example: 102.
Response: The PPP Synchronous Port Configuration menu is displayed.
4. At Port type, enter X.25 line. (Use the return key to change.)
Response: The X.25 Port Configuration menu is displayed.
5. At the X.25 Port Configuration menu, enter the following information: (Use the
arrow keys to navigate the screen)
• At Port name, enter NFM.
• At Connection Mode, enter DTE (Use the return key to change.)
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.8
Issue 3.00 Page 3.8-3
To Next Page
Loading...