• At Permanent/Number of VCs, enter 3.
6. Press the left arrow twice.
Response: The cursor is positioned at Process Selections (Y/N).
7. Enter Y
Response: The Configure Port menu is displayed.
8. Enter <Ctrl>w.
9. Press the <Esc> key until the main menu is displayed.
Response: The main menu is displayed.
3.9.4.2 Assign XOT and define the remote IP Address, port and LCN
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 10 for X.25.
Response: The X.25 Parameters menu is displayed.
3. Enter 5 for XOT switching table.
Response: The XOT PVC SCV Switching Table is displayed.
4. For each of the 7 LCNs, enter the following information: (Use the arrow keys to
navigate the screen)
• At Service, enter PVC/XOT (Use the return key to change.)
• At LOCAL PORT #, enter the port number for the OS Router that handles
EADAS traffic.
• At LOCAL LCN #, enter 1, 2, 3, 4, 5, 6,or7
• At REMOTE PORT #, enter 204
• At REMOTE LCN #, enter 1, 2, 3, 4, 5, 6,or7
• At REMOTE IP Address, enter the IP Address for the OS Router that handles
EADAS traffic
5. Press the left arrow key twice.
Response: The cursor is positioned at Process Selections (Y/N).
6. Enter Y.
7. Hold down the Ctrl key and press the W key.
8. Hold down the Ctrl key and press the ] key.
9. Enter quit
10. Perform Procedure 8.11.7 to verify operations of TDMS/EADAS Data Link
11. Perform Procedure 8.11.8 to back up office dependent data.
NETWORK PROCEDURES
Procedure 3.9
235-200-150
January 2003
Page 3.9-4 Issue 3.00
To Next Page
Loading...
Need help?
General