5. Press the left arrow key twice.
Response: The cursor is positioned at Process Selections (Y/N).
6. Enter Y.
7. Hold down the Ctrl key and press the W key.
8. Hold down the Ctrl key and press the ] key.
9. Enter quit
10. Perform Procedure 3.3, Back up the DynaStar 500
1
3.9.4 At the Host Site, Connect the OSS Router to the Router at the DRM Site
3.9.4.1 Connect the EADAS to the OSS Router
Note: If the remote OS router is not to be used to set up a permanent connection for
IP routing from a router at the DRM site, use local procedures instead of the following
procedure to set up the permanent connection for IP routing between the remote
router and the OS router
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 2 for port.
Response: The Configure Port menu is displayed.
3. Enter the port number to which you wish to connect.
Note: The last number of the port number is the slot number on the back of the
DynaStar.
If you want to connect to port 2, choose the port number that ends with 2. For
example: 102.
Response: The PPP Synchronous Port Configuration menu is displayed.
4. At Port type, enter X.25 line. (Use the return key to change.)
Response: The X.25 Port Configuration menu is displayed.
5. At the X.25 Port Configuration menu, enter the following information: (Use the
arrow keys to navigate the screen)
• At Port name, enter EADAS.
• At Connection Mode, enter DTE (Use the return key to change.)
• At Line Speed, enter 64 Kbps (Use the return key to change.)
• At X.25 mode, enter DTE (Use the return key to change.)
• At Max Packet size, enter 256 (Use the return key to change.)
• At IPX Routing, enter N.
• At Ethernet Routing, enter N (Use the return key to change.)
1. Trademark of DYMEC, Inc.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.9
Issue 3.00 Page 3.9-3
To Next Page
Loading...
Need help?
General