• At Trunk Name, enter PRI
• At FrameType, enter D4. (Use return key to change.)
6. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
7. Enter y.
8. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
3.10.1.2 Assign Incoming Telephone Number for the PRI
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 2 for port.
Response: The Configure Port menu is displayed.
3. Enter 300 for PRI.
Response: The T1 Trunk Parameters menu is displayed.
4. Enter 2 for Configure Incoming Telephone Number and SPIDs.
5. Enter the PRI access telephone number.
6. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
7. Enter y.
8. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
3.10.1.3 Assign Router 00, PRI IP Addresses/Masks/Protocols
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 3 for router.
Response: The Router Commands menu is displayed.
3. Enter 5 for IP Port Information.
Response: The IP Port Information menu is displayed.
4. At the IP Port Information menu, enter the following information: (Use the arrow
keys to navigate the screen.)
• At IP Address, enter the PRI IP Address.
• At IP mask, enter the PRI port IP mask
• At Protocol, enter RIP II. (Use the return key to change.)
NETWORK PROCEDURES
Procedure 3.10
235-200-150
January 2003
Page 3.10-2 Issue 3.00
To Next Page
Loading...