5. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
6. Enter Y.
7. Hold down the Ctrl key and press the w key.
Response: The settings are saved to flash.
8. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
3.10.2 Save the Configuration Files Remotely
3.10.2.1 Host Networking Router Configuration File Back Up Procedure
1. Perform Procedure 3.4, Backup The DynaStar 500
1
(Base/Growth) Router at the
Host Site, to remotely save the configuration files.
3.10.2.2 Connect the Router to BRI Port 301 and the MDF
1. At the DRM site, connect the router to BRI port 301 and the MDF.
3.10.3 Program the BRI at the remote router
3.10.3.1 PPP Dial Entry to access the PRI
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 1 for PPP Dial Directions.
Response: The PPP Dial Directions menu is displayed.
3. Press Return.
Response: The PPP Dial Directory Entry menu is displayed.
4. Enter the following information: (Use the arrow keys to navigate the screen.)
• At the Location Name, enter BRI to Host.
• At ISDN Interface, enter BRI
• At PhoneNumber, enter the PRI Access telephone number.
• At IP Routing, enter y (Use the return key to change.)
• At the Remote IP address, enter the PRI port IP Address of Router 00 at the
Host Site
• At the Local IP address, enter the BRI port IP Address of the router at the
DRM site
For example, 10.10.8.26
1. Trademark of DYMEC, Inc.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.10
Issue 3.00 Page 3.10-3
To Next Page
Loading...
Need help?
General