3.10.4 Verify that BRI to PRI backup connection is established
1. Login to the Remote-Networking Router.
1. Go to the call status page and watch the call status.
2. At the Main Menu, enter 1.
3. Enter 2.
2. Remove the T1 connection from port on the Remote-Networking Router. After 150
seconds the BRI to PRI backup connection is established. The call status page
should indicate that it has been done.
3. Restore the T1 connection, the call status should be disconnected.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.10
Issue 3.00 Page 3.10-7
To Next Page
Loading...