2. Enter 3 for router.
Response: The Router Commands menu is displayed.
3. Enter 5 for IP Port Information.
Response: The IP Port Information menu is displayed.
4. At the IP Port Information menu, enter the following information for the BRI
port: (Use the arrow keys to navigate the screen.)
• At IP Address, enter the BRI IP Address.
For example, 10.10.8.26
• At IP mask, enter the BRI port IP mask
• At Protocol, enter RIP II. (Use the return key to change.)
5. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
6. Enter y.
3.10.3.5 Add the BRI as a T1 back up (T1 connection to host) to the TDM Channel
(port 8)
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
2. Enter 2 for port.
Response: The Configure Port menu is displayed.
3. Enter 8 for T1 to Host.
Response: The Frame Relay Port Configuration menu is displayed.
4. Enter the following information: (Use the arrow keys to navigate the screen.)
• At Circuit Backup, enter Y. (Use return key to change.)
• At Backup when line Down, enter 150.
• At Restore when line Up, enter 30.
• At Backup Location Name, enter BRI to Host.
5. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
6. Enter y.
7. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
8. Hold down the Ctrl key and press the w key.
Response: The settings are saved to flash.
NETWORK PROCEDURES
Procedure 3.10
235-200-150
January 2003
Page 3.10-6 Issue 3.00
To Next Page
Loading...