5. Enter the following information in slot 1: (Use the arrow keys to navigate the
screen.)
• At Telephone #, enter circuit-switched data telephone number of the BRI
• At SPID, enter the service Profile ID for the BRI
6. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
7. Enter y.
8. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
9. Configure ISDN B Channel Port Configuration.
At the main menu, enter 3.
10. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
11. Enter 2 for port.
Response: The Configure Port menu is displayed.
12. Enter 300 for BRI.
Response: The ISDN Port Configuration menu is displayed.
13. Enter 3 for B Channel Ports.
Response: The IP Port Information menu is displayed.
14. Enter the following information for Port 301 and Port 302: (Use the arrow keys
to navigate the screen.)
• At Use, enter IN/OUT. (Use the return key to change.)
• At Inbound Tel #, enter the 10 digit telephone # for the BRI
• At Protocol, enter PPP.
• At Class, enter NONE.
• At ML, enter N.
15. Press the left arrow.
Response: The cursor is positioned at process selections (Y/N).
16. Enter y.
17. Press the esc key until the main menu is displayed.
Response: The main menu is displayed.
3.10.3.4 Configure PRI Board Addresses/Masks/Protocols
1. Enter 3 for configuration.
Response: The Configuration Commands menu is displayed.
235-200-150
January 2003
NETWORK PROCEDURES
Procedure 3.10
Issue 3.00 Page 3.10-5
To Next Page
Loading...