This command will force a switch-over to the master module
and disconnect your telnet session
*** Reset *** - do you want to continue (Y/N)?
f. Type and enter the "yes" confirmation:
y
Response:
Connection closed by foreign host.
The "Login:″ prompt will be displayed shortly after.
g. Type and enter the "Supervisor Level" login name:
root
Response:
The "Password:″ prompt will be displayed.
h. Type and enter the "Supervisor Level" password:
root
Response:
Password accepted.
P330-1(super)#
i. Type and enter the following to verify the correct set-up of the IP Address:
show interface
Response:
Interface Name VLAN IP address Netmask
--------------- ------- ----------------- ----------------
inband 1 10.10.1.245 255.255.255.0
ppp disabled 1 0.0.0.0 0.0.0.0
j. Type and enter the following to log off:
exit
Response:
The "Login:″ prompt will be displayed.
13. Verify connectivity between the ASM and Host Routers through the replacement
Cajun switch as follows:
a. From the ASM UNIX console, login to the ASM UNIX shell.
b. Type and enter the following to verify connectivity between the ASM and the
replacement Cajun switch:
ping 10.10.1.245
Response:
10.10.1.245 is alive
c. Type and enter the following to verify connectivity between the ASM and all
Host Routers that are configured on the network (see Table 3.14-3):
235-200-150
October 2004
NETWORK PROCEDURES
Procedure 3.14
Issue 3.00L Page 3.14-5
To Next Page
Loading...
Need help?
General