If YES, continue with Step 5.
If NO, skip to Step 7.
5. Remove the primary disk drive from the lower disk drive slot by pushing the
latch to the right, extending the drive handle, and pulling the disk from the drive
bay.
6. Install the secondary disk drive removed in step 3 into the lower disk drive slot;
pushing the disk into the drive bay until contact is made with the backplane
connector. Push the drive handle to lock the drive into the system.
7. Install the replacement disk drive in the upper disk drive slot; pushing the disk
into the drive bay until contact is made with the backplane connector. Push the
drive handle to lock the drive into the system.
8. Replace the front ESD plate using a No.1 Phillips-head screwdriver to tighten
the three retaining screws holding the ESD plate.
9. Replace the front access cover by lifting into place against the AW chassis and
twisting the two locking rings clockwise to the lock position.
10. Restore power to the AW. See "Restore Power to Administrative Workstation
(Netra t 1120 and Netra 20)", Procedure 4.8.
11. Is the system booted and running the emulated AM environment?
If YES, proceed with Step 12.
If NO, seek technical assistance.
12. Proceed to "Partition and Propagate the System to the Non-Active Disk,"
Subprocedure 4.5.6
13. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.1
235-200-150
March 2006
Page 4.5.1-2 Issue 3.00M
To Next Page
Loading...
Need help?
General