1) Change the Workstation Default Boot Disk to Primary Disk
2) Change the Workstation Default Boot Disk to Secondary Disk
3) Return to the Main Menu
Select task by number (1-3): 2
• If prompted to set the primary disk as the default boot disk, enter no.
Response:
Do you want to change the default boot device to the primary disk
(disk0)? no
• If prompted to set the secondary disk as the default boot disk, enter yes.
Response:
Do you want to change the default boot device to the secondary disk
(disk1)? yes
18. The previous Step prompts you to "Press return to continue...". If you have not
done so already, enter [RETURN] or [ENTER] on the alpha keypad to continue.
19. From the Administrative Workstation Main Menu, select "Exit″.
20. At the login prompt, login as root. Obtain the root password for the AW from
Lucent TSS if necessary.
21. Enter the following command to set the system crash dump device to the
secondary disk.
dumpadm -d /dev/dsk/c1t1d0s1
22. Enter the following command to determine the correct Ap_Id label for the
primary disk drive.
cfgadm -al
Response:
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected configured unknown
c2::rmt/0 tape connected configured unknown
23. Enter the following command to prepare the defective primary disk for removal.
cfgadm -c unconfigure c1::dsk/c1t0d0
24. Enter the following command to verify that the primary disk is unconfigured.
cfgadm -al
Response:
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.4
Issue 3.00B Page 4.5.4-3
To Next Page
Loading...
Need help?
General