• If prompted to set the primary disk as the default boot disk, enter yes.
Response:
Do you want to change the default boot device to the primary disk
(disk0)? yes
• If prompted to set the secondary disk as the default boot disk, enter no.
Response:
Do you want to change the default boot device to the secondary disk
(disk1)? no
39. The previous Step prompts you to "Press return to continue...". If you have not
done so already, enter [RETURN] or [ENTER] on the alpha keypad to continue.
40. From the Administrative Workstation Main Menu, select "Exit".
41. Halt the AM emulator by following procedure 4.1 , "Halt the Administrative
Module (AM) Emulator".
42. If the MCC page of the AW is displayed, switch to the SUN console by holding
down the [Ctrl] key and pressing the [Enter] key on the numeric keypad.
43. Repeatedly press [RETURN] or [ENTER] on the alpha keypad until a login
prompt appears.
44. At the login prompt, login as awadmin.
45. From the Administrative Workstation Main Menu, select "Boot the Workstation".
Answer yes to the confirmation. If you select a task by mistake, answer no to the
confirmation.
Response:
You have chosen to boot the workstation. If the Emulator is running,
it must be halted before continuing. Refer to the Main Menu item of
Halt the Emulator
.
Do you want to continue? (yes/no) yes
The AW will boot on the primary disk and automatically start the AM emulator.
46. Is the system booted and running the emulated AM environment?
If YES, then continue with the next Step.
If NO, seek technical assistance.
47. If a login prompt does not appear, repeatedly press [RETURN] or [ENTER] on the
alpha keypad until one appears.
48. At the login prompt, login as root. Obtain the root password for the AW from
Lucent TSS if necessary.
49. Enter the following command to set the system crash dump device to the primary
disk.
dumpadm -d /dev/dsk/c1t0d0s1
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.5.4
Issue 3.00B Page 4.5.4-7
To Next Page
Loading...
Need help?
General