— Holding the drive handle, insert the secondary disk drive into the upper drive
bay until contact is made with the backplane connector. Push the drive
handle to lock the drive into the system.
— Replace the front ESD plate using a No.1 Phillips-head screwdriver to tighten
the three retaining screws holding the ESD plate.
— Replace the front access cover by lifting into place against the AW chassis
and twisting the two locking rings clockwise to the lock position.
For a Netra 20:
— Holding the drive handle, insert the primary disk drive into the left drive bay
until contact is made with the backplane connector. Push the drive handle to
lock the drive into the system.
— Holding the drive handle, insert the secondary disk drive into the right drive
bay until contact is made with the backplane connector. Push the drive
handle to lock the drive into the system.
— Replace the front access cover by pressing the cover into place on the AW
chassis.
13. Install the mounting brackets that were removed in Step 9 onto the replacement
AW.
14. Slide the AW into the mounting brackets on the frame.
15. Secure the AW to the frame using the mounting screws that were removed in
Step 7.
16. Connect the cables that were removed in Step 6 to the rear of the replacement
AW.
17. Restore power to the AW. See "Restore Power to Administrative Workstation,"
Procedure 4.8.
18. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
235-200-150
January 2006
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.6
Issue 3.00L Page 4.6-11
To Next Page
Loading...