— Remove the primary disk drive from the left disk drive slot (See Figure
4.6-14) by pushing the latch downward, extending the drive handle, and
pulling the disk from the drive bay.
— Label the disk. For example, "Office Primary Disk."
— Remove the secondary disk drive from the right disk drive slot (See Figure
4.6-14) by pushing the latch downward, extending the drive handle, and
pulling the disk from the drive bay.
— Label the disk. For example, "Office Secondary Disk."
11. Repeat Step 10 to remove the disk drives from the replacement AW. Label these
drives as “Spare Disk”.
12. Install the disk drives, removed from the AW being replaced, into the
replacement AW.
For a Netra t 1120:
— Holding the drive handle, insert the primary disk drive into the lower drive
bay until contact is made with the backplane connector. Push the drive
handle to lock the drive into the system.
Figure 4.6-14 — Removal of the
Netra
20 Hard Drives
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.6
235-200-150
January 2006
Page 4.6-10 Issue 3.00L
To Next Page
Loading...