13. Replace the front access cover by lifting into place against the AW chassis and
twisting the two locking rings clockwise to the lock position.
14. Replace the top cover of the AW.
a. Position the cover over the system with the screw holes at the front and the
slots on each side lined up with the lugs on the sides of the AW.
b. Push the cover forwards until the lugs on the sides are locked in the slots.
c. Replace the screws on the front of the cover.
Note: If the AW was removed from the frame Step 3, install the AW into the
frame. See "Replace System Unit (Netra t 1120 or Netra 20)”, Procedure 4.6.
15. Restore power to the AW. See "Restore Power to Administrative Workstation
(Netra t 1120 or Netra 20)”, Procedure 4.8.
16. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
235-200-150
October 2005
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.11
Issue 3.00L Page 4.11-3
To Next Page
Loading...