12. Replace the top cover of the AW.
a. Position the cover over the system with the captive screws at the rear and
the lugs on each side lined up with the slots on the sides of the AW.
b. Push the cover forwards until the lugs on the sides are locked in the slots.
c. Tighten the screws on the rear of the cover.
Note: If the AW was removed from the frame in Step 2, install the AW into the
frame. See "Replace System Unit (Netra t 1120 or Netra 20)”, Procedure 4.6.
13. Restore power to the AW. See "Restore Power to Administrative Workstation
(Netra t 1120 or Netra 20)”, Procedure 4.8.
14. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
235-200-150
March 2006
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.12
Issue 3.00M Page 4.12-3
To Next Page
Loading...
Need help?
General