3. Open the front access cover by pulling the cover away from the top of the AW
chassis using the finger hold in the center of the cover.
4. Loosen the two captive screws on top of the DAT or DVD drive that will be
replaced. See Figure 4.12-2.
5. Disconnect the SCSI and power connectors from the rear of the DAT or DVD
drive.
6. Pull the DAT or DVD drive out from the front of the AW chassis.
7. Make sure that all jumper connectors on the set of pins located near the SCSI
bus and power connectors at the rear of the replacement DAT or CD-ROM/DVD
drive match the jumper connectors on the rear of the drive being replaced.
Note: The SCSI ID is set using jumper connectors on the set of pins at the rear
of the drive. The jumper connectors must be configured so that the SCSI ID for
the DAT drive is set to 5 and the SCSI ID of the CD-ROM/DVD drive is set to 6.
8. Insert the replacement DAT or DVD drive into the AW chassis so that the eject
button is at the bottom left hand side of the faceplate.
9. Connect the SCSI and power cables to the rear of the replacement DAT or DVD
drive.
10. Tighten the two captive screws securing the replacement DAT or DVD drive to
the drive assembly.
11. Replace the front access cover by pressing the cover into place on the AW chassis.
Figure 4.12-2 — Removal of
Netra
20 DAT or DVD
ADMINISTRATIVE WORKSTATION MAINTENANCE
Procedure 4.12
235-200-150
March 2006
Page 4.12-2 Issue 3.00M
To Next Page
Loading...