To Next Page

To Previous Page

1234567890123456789012345678901212345678901234567890123456

(b) For selection 2, the following questions are displayed:

QUESTION 1:

Equipment status (default XXX)?

(1) INSTALLING

(2) PRE-CUT

(3) IN SERVICE

Please enter the selected number, or <ENTER> for no change:

QUESTION 2:

24 hour indicator (default XXX)?

(1) YES

(2) NO

Please enter the selected number, or <ENTER> for no change:

QUESTION 3:

Circuit Pack Code (default XXX)

Please enter new circuit pack code or <ENTER> for no change:

QUESTION 4:

Series (default XXX)

Please enter new series/version number or <ENTER> for no change:

QUESTION 5:

Serial number (default XXX)

Please enter new serial number for the circuit pack

or <ENTER> for no change:

Where: XXX = The respective current default data.

After getting all the answers to the five questions, redisplay what the user

has entered. Then the following will be displayed:

Do you want to save these changes?

Please enter y for yes, or n for no, or q to quit:

This will take the dialogue flow back to Step 4.

(d) For selection 4, quit the RTAG user interface.

5. STOP. YOU HAVE COMPLETED THIS PROCEDURE.

235-200-150

January 2003

CORRECTIVE MAINTENANCE

Procedure 6.4

Issue 3.00 Page 6.4-5

Lucent 5ESS DRM User Manual

Questions and Answers: