partitions are
preserved.
Do you want to continue? (yes/no) yes
This task will take approximately 30 minutes. When it is completed, you will be
prompted to press Return. When the prompt appears, press Return.
6. Skip to Step 9.
7. Insert the Emulator and Operating System backup tape into the DAT drive using
“Load Tape in DAT Tape Drive Unit,” Procedure 4.19.
8. From the main menu, select “Format and Load the Primary Disk from Backup
Tape.” Answer yes to the confirmation. If you select a task by mistake, answer
no to the confirmation.
Response:
You have chosen to format and load the primary disk from a backup
tape. Please ensure that an Emulator and Sun OS backup tape is in
the DAT drive.
WARNING:
If you continue, the primary disk operating system partitions will
be overwritten with data from the backup tape and its MHD partitions
are preserved.
Do you want to continue? (yes/no) yes
This task will take approximately 30 minutes. When it is completed, you will be
prompted to press Return. When the prompt appears, press Return.
9. From the main menu, select “Exit and Boot the Workstation” (5e14.1 – 5e16.1) or
“Boot the Workstation on the Default Boot Disk” (5e16.2 and later). Answer yes
to the following confirmation. If you select a task by mistake, answer no to the
confirmation
Response:
You have chosen to boot the workstation...
Do you want to continue? (yes/no) yes
The AW will boot and automatically start the AM emulator.
10. Is the AW booted?
If YES, Continue with “Propagate Primary Disk to Secondary Disk,” Procedure
7.1.2.
If NO, seek technical assistance.
235-200-150
October 2005
SYSTEM RECOVERY
Procedure 7.1.1
Issue 3.00 Page 7.1.1-3
To Next Page