Lucent 5ESS DRM - Page 391

To Next Page

To Previous Page

1234567890123456789012345678901212345678901234567890123456

11. At the RDLDFT display prompt, type and enter: m

Response:

Please enter session number:

12. At the RDLDFT display prompt, type and enter: the session number [1-9] from

Step 1.

Response:

Please enter volume number:

13. At the RDLDFT display prompt, enter 3 for the volume number for SM Text.

Response:

What tape density is to be used?

Please enter the number ’8’ for low density or

the number ’0’ for high density:

14. At the RDLDFT display prompt, type and enter: 8 for the low tape density

identifier.

15. Once the tape density identifier has been selected, the following statement will

be displayed. Observe the statement, then continue with next step.

RDLDFT: SM TEXT tape sequence chosen for /dev/vtoc1 on /dev/mtxx

RDLDFT: Please mount the first backup tape on the tape drive

and insure that the ONLINE button is ON.

Please enter ’go’ after the tape is mounted:

Note: If this statement is not received within a few seconds, monitor ROP for

REPT FMGR UMOUNT FAILED output message and seek technical assistance

to identify process that is blocking UNMOUNT of SM text file system.

16. Make sure the switching module text tape is mounted, ensure that the tape drive

ONLINE button is ON, and then type and enter: : go

Note: As the tape is being loaded to disk, a tape load forward progressing dot

will appear on the terminal approximately every 30 seconds. Once the tape load

has completed, the following message will be printed.

Response: RDLDFT COMPLETED

RCV MENU RDLDFT COMPLETED

17. Was the RDLDFT COMPLETED message received?

If YES, switching module text has been loaded. Continue with the next step.

If NO, seek technical assistance.

18. Was rdldft invoked from the MCC?

If YES, exit from UNIX shell, type and enter: q and exit from the MCC Page 194,

type and enter: q

235-200-150

January 2003

SYSTEM RECOVERY

Procedure 7.2.2

Issue 3.00 Page 7.2.2-3