Lucent 5ESS DRM - Page 390

To Next Page

To Previous Page

1234567890123456789012345678901212345678901234567890123456

Depress PF3 key twice to reconnect to the SCREEN process if

the Command Message Key (PF3) has been used during this procedure.

What is the desired command?

o) ODBE c) CNIDBOC

a) ACCED r) RTAG

u) UNIX SHELL Q) TO QUIT

Please enter o,a,u,c, r, or Q:

Character mappings

\:, \1, \s, \8, \−, \a, \/, \\, \

;, !, $, &, -, @, ?, \,

4. Enter the UNIX

mode. Type and enter: u

5. Invoke rdldft. Type and enter: /usr/bin/rdldft

Note: When using the MCC, the screens displayed by rdldft will not paint as it

does when used with an STLWS. Some lines in the screens which follow may not

be displayed. Commands are entered in the upper left corner and displayed next

to the rdldft prompt after pressing the RETURN key.

6. Go to Step 9.

7. Clear the screen with a 120 poke.

8. The tape to be mounted is the switching module text tape for MHD2/MHD3

(/dev/vtoc1) with the same software update level marking on the tape label as the

software update level of the AM text that was just booted.

Type and enter: RCV:MENU:RDLDFT;

Response:

Please enter the tape drive number.

Please enter the number ’0’ for tape drive MT0 or

the number ’1’ for tape drive MT1, etc.:

9. At the RDLDFT display prompt, type and enter: 0

Response:

Please enter the letter ’x’ for SM TEXT or

the letter ’s’ for SM ODD:

10. At the RDLDFT display prompt, type and enter: x to load SM Text.

Response:

What tape volume format is to be used?

Please enter ’m’ for Multi-volume format or

’s’ for Single-volume format:

1. Registered trademark in the United States and other countries, licensed exclusively through X/Open

Company, Limited

SYSTEM RECOVERY

Procedure 7.2.2

235-200-150

January 2003

Page 7.2.2-2 Issue 3.00

Main Page

Lucent 5ESS DRM - Page 390

Table of Contents