7.2.2 Restore Switching Module Text on Outboard MHDs
OVERVIEW
If an MHD2/MHD3 switching module text tape (/dev/vtoc1) at the same software
update level as the AM text (/dev/vtoc) restored from the backup media is not
available, install an older tape now and obtain a tape of the same software update
level as the /no5text partition to install later.
PROCEDURE
1. Mount the tape on the tape drive.
At the MCC, type and enter: DUMP:BKTAPE:TD="x"
Where: x = Pathname of the tape special device file.
Response: DUMP BKTAPE TD x STARTED
For each logical volume on the tape, the following response appears:
Response: DUMP BKTAPE TD x IN PROGRESS
SESSION VOLUME NAME BLOCKS SOURCE DATE
abcdef
Where: a = Backup session number.
b = Logical volume number.
c = Logical volume name.
d = Number of blocks for the logical volume.
e = Source disk(s) logical volume was written from.
f = Date logical volume was written.
After all logical volumes have been processed, the following response appears:
Response: DUMP BKTAPE TD x COMPLETED
CUMULATIVE BLOCKS a
Where: a = Cumulative number of blocks for all logical volumes.
Note the session number and volume number of the SM TEXT backup to be read
into the partitions.
2. Is an STLWS available?
If YES, go to Step 7.
If NO, continue with the next step.
3. At the MCC, type and enter: 194
Response:
235-200-150
January 2003
SYSTEM RECOVERY
Procedure 7.2.2
Issue 3.00 Page 7.2.2-1
To Next Page
Loading...
Need help?
General