Lucent 5ESS DRM - Page 393

To Next Page

To Previous Page

1234567890123456789012345678901212345678901234567890123456

7.2.3 Restore the Switching Module ODD

OVERVIEW

The following steps will install the switching module ODD disk image from backup

switching module ODD tapes.

PROCEDURE

1. Mount the tape on the tape drive.

At the MCC, type and enter: DUMP:BKTAPE:TD="x"

Where: x = Pathname of the tape special device file.

Response: DUMP BKTAPE TD x STARTED

For each logical volume on the tape, the following response appears:

Response: DUMP BKTAPE TD x IN PROGRESS

SESSION VOLUME NAME BLOCKS SOURCE DATE

abcdef

Where: a = Backup session number.

b = Logical volume number.

c = Logical volume name.

d = Number of blocks for the logical volume.

e = Source disk(s) logical volume was written from.

f = Date logical volume was written.

After all logical volumes have been processed, the following response appears:

Response: DUMP BKTAPE TD x COMPLETED

CUMULATIVE BLOCKS a

Where: a = Cumulative number of blocks for all logical volumes.

Note the session number and volume number of the SM TEXT backup to be read

into the partitions.

2. Is an STLWS available?

If YES, go to Step 7.

If NO, continue with the next step.

3. At the MCC, type and enter: 194

Response:

Depress PF3 key twice to reconnect to the SCREEN process if

the Command Message Key (PF3) has been used during this procedure.

What is the desired command?

o) ODBE c) CNIDBOC

a) ACCED r) RTAG

u) UNIX SHELL Q) TO QUIT

Please enter o,a,u,c, r, or Q:

Character mappings

\:, \1, \s, \8, \−, \a, \/, \\, \

;, !, $, &, -, @, ?, \,

235-200-150

January 2003

SYSTEM RECOVERY

Procedure 7.2.3

Issue 3.00 Page 7.2.3-1

Main Page

Lucent 5ESS DRM - Page 393

Table of Contents