To Next Page

To Previous Page

1234567890123456789012345678901212345678901234567890123456

4. Enter UNIX

shell. Type and enter: u

5. Invoke rdldft. Type and enter: /usr/bin/rdldft

Note: When using the MCC, the screens displayed by rdldft will not paint as it

does when used with an STLWS. Some lines in the screens which follow may not

be displayed. Commands are entered in the upper left corner and displayed next

to the rdldft prompt after pressing the RETURN key.

6. Go to Step 9.

7. Clear the screen, type and enter: 120

8. At the command prompt, start the load disk from tape program.

The Volume Table Of Contents (VTOC) to be selected must be the same as the

/dev/vtocx on each of the switching module ODD backup tape labels. The

switching module ODD tape must have been made in the same software release

backup session as the AM ODD tape which was used in the recovery.

Type and enter: RCV:MENU:RDLDFT;

Response:

Please enter the tape drive number.

Please enter the number ’0’ for tape drive MT0 or

the number ’1’ for tape drive MT1, etc.:

9. At the RDLDFT display prompt, type and enter: 0

Response:

Please enter the letter ’x’ for SM TEXT or

the letter ’s’ for SM ODD:

10. At the RDLDFT display prompt, type and enter: s to load SM ODD.

Response:

What tape volume format is to be used?

Please enter ’m’ for Multi-volume format or

’s’ for Single-volume format:

11. At the RDLDFT display prompt, type and enter: m

Response:

Please enter session number:

12. At the RDLDFT display prompt, type and enter: the session number [1-9] from

Step 1.

Response:

1. Registered trademark in the United States and other countries, licensed exclusively through X/Open

Company, Limited

SYSTEM RECOVERY

Procedure 7.2.3

235-200-150

January 2003

Page 7.2.3-2 Issue 3.00

Lucent 5ESS DRM User Manual

Questions and Answers: