(a) Type and enter: toggle
Response: Will take you to the high-level forms.
3. Insert SDL data.
(a) Type and enter: sdladd
Response: ttyadd form displayed. Cursor at 1. sdl_name:
Note: An ! may be entered any time prompted to abort the form and
return to the state when the form was started.
(b) Type and enter the following data:
1. sdl_name: enter SDL13.
2. port: enter 1
3. AMA_baud_rate: enter one of the following:
4800DIAL
9600DIAL
9600PRI
56000PRI
56000SW
Note: Fields not specified receive the default value by entering
CARRIAGE RETURN.
(c) Type and enter: i
(d) The low-level forms will now be added automatically.
4. Install the AMA data link. The AMA data link consists of a modem and modem
cable connected to the High Speed Bus controller interface. (Figures 8.8-1, 8.8-2
and 8.8-3 provide an illustration of the hardware connections for the AMA data
link.)
(a) Enter CARRIAGE RETURN
3. Trademark of Sun Microsystems, Inc.
GROWTH AND DEGROWTH
Procedure 8.8
235-200-150
October 2005
Page 8.8-2 Issue 3.00B
To Next Page
Loading...