Table A1-2 — KS-24697
Sun
Console/MCC Terminal Settings
Field Name Value
Name Unix
Serial Port /dev/ttyS0
Baud 9600
Data Bits 8
Stop Bits 1
Parity None
Note: To get into the options page press CTRL-SHIFT-S to open the settings menu,
then go to Communications Setup by highlighting “Communications” and then enter.
If Serial Host is not Unix , tab to Cancel and hit enter then CTRL-ENTER to toggle
sessions and start over. Tab to Configure then enter. To save the settings, tab to OK
and hit enter on both menus. If no output is given, enter a ^Q(CTRL_Q) and hit
return a couple of times.
235-200-150
August 2003
APPENDIX 1
SUN
CONSOLE/MASTER CONTROL CENTER (MCC)
TERMINAL SETTINGS
Issue 3.00 Page A1-3
To Next Page
Loading...