Table A1-1 — KS-23996
Sun
Console/MCC Terminal Settings (Contd)
EIA Baud Rate = 9600
EIA Data Format = 7/1/E EIA Parity Check = off
Aux Baud Rate = 9600 Aux Data Format = 8/1/N Aux Parity Format = off
EIA Xmt = Xon-Xoff EIA Recv = Xon-Xoff (XPC) EIA Xmt Pace = Baud
Aux Xmt = Xon-Xoff Aux Recv = Xon-Xoff (XPC) Aux Xmt Pace = Baud
EIA Break = 250 ms EIA Modem Control = off EIA Disconnect = 60 ms
Aux Break = 250 ms Aux Modem Control = off Aux Disconnect = 60 ms
F7 Screen
Comm Mode = Full Duplex Local = off Recv <CR> = <CR>
Recv <DEL> = Destruct BS Send ACK = off Send Block Term = None
Send Region = Screen Send End = Region Null Suppress = on
F8 Screen
Prnt Mode = Normal Prnt Region = Screen Prnt Block Term = None
Secondary Recv = off
F9 Screen
Numeric Kpd = Numeric Cursor Kpd = Cursor Send Data = All
Print = Multinational ANSI-ID = VT100 Function Key Lock = on
UPSS =
ANSI-Supplemental
Feature Lock = off Status Line = off
F11 Screen
Answerback Mode = off
F12 Screen
Key = F1 Program = F/Key Key Dir = Comm
Dependent
Note: To get into the options page press CNTL-ALT-F3. Toggle between sessions
with CNTL Enter (on numeric pad). To exit press F14.
Table A1-2 lists terminal settings that should be set when growing a KS-249697 Sun
Console or MCC terminal. Table A1-2 should also be used to verify terminal option
settings in case of a terminal lock-up.
APPENDIX 1
SUN
CONSOLE/MASTER CONTROL CENTER (MCC)
TERMINAL SETTINGS
235-200-150
August 2003
Page A1-2 Issue 3.00
To Next Page
Loading...