0455 –– Recent Change Kernel Process (RCKP).
0460 –– Operational kernel process (OKP).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
zzzz = Failed process sequence state:
000A –– AIM timed out waiting for a PMGR response.
yyyy –– PMGR failure code. See UNIX RTR PMGR error
codes in Appendix C, 235-600-700, Input Messages Manual,
or convert from hexadecimal to decimal and consult the
REPT:PMGR output message in 235-600-750, Output
Messages Manual, for an explanation.
hh hh hh = Hardware status digits. Refer to Figure A2-1 for definition
of the digits.
A2.2.4.5 Explanation
AIM prints this PRM to report that it was unable to create an essential process.
If AM software checks are allowed, AIM will immediately trigger a high-level AM
initialization. Otherwise, no initialization will occur. However, the system may not
support essential functionality (such as call processing, maintenance, or input/output).
A2.2.4.6 Corrective Action
If several minutes elapse without recovery, go into UNIX RTR operating system
minimum configuration. Using the process manager error code and the process
identity, check that the disk files necessary for process creation are in their correct
directory locations and contain the correct header information.
If this fails to correct the problem, see “Analyze AM Initialization Failure,”
235-105-250, 5ESS Switch System Recovery Manual.
A2.2.5 PRM:vE FF05
A2.2.5.1 PRM Format
PRM_p vEda FF05 xxxx yyzz hh hh hh
A2.2.5.2 PRM Source
Application Integrity Monitor (AIM) Phase Trigger.
A2.2.5.3 Function
AIM essential UNIX RTR operating system application process initialization failure.
A2.2.5.4 PRM Expansion
235-200-150
January 2003
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
Issue 3.00 Page A2-11
To Next Page
Loading...