p = Active control unit (CU):
0––CU0
1––CU1
v = E - Administrative Module (AM) software checks are
inhibited (see “Explanation,” Section A2.2.7.5).
F - AM software checks allowed. A high level AM
initialization will follow immediately.
E = Application software generated this PRM.
d = Level of most recent UNIX RTR operating system
initialization:
0 –– No initialization or D0 initialization.
1 –– D1 initialization.
2 –– D2 initialization.
3 –– D3 initialization.
4 –– D4 initialization.
These initializations are explained in 235-105-250, 5ESS
Switch System Recovery.
a = Application initialization level within the UNIX RTR
operating system initialization specified in field ’d’.
FF1B = Application function = DRM phase trigger = essential
process FPI timeout.
wwww = UNIX RTR operating system application process utility ID:
0017 –– First in-first out (FIFO) driver (FDA).
00C0 –– Input/output driver (IODRV).
00C2 –– Scan and signal distributor administration
(SCSD).
0CC –– RTR Data Link Driver for DRM
0117 –– Plant measurement database monitor (PLDMON).
0186 –– Kernel level overload monitor (KLMON)
0410 –– Switch maintenance kernel process (SMKP).
0420 –– Communications kernel process (CMKP).
0430 –– Message switch kernel process (MSKP).
0455 –– Recent Change Kernel Process (RCKP)
0460 –– Operational kernel process (OKP).
7ED –– Communications Module Processor Kernel Process
(CMPKP)
x = Failed process sequence state.
0 –– Created (booted from disk).
1 –– Software initialization.
2 –– Hardware initialization.
3 –– Communication link initialization.
4 –– Enable fault recovery.
5 –– Essential jobs operational.
APPENDIX 2
PROCESSOR RECOVERY MESSAGES
235-200-150
January 2003
Page A2-16 Issue 3.00
To Next Page
Loading...