EasyManua.ls Logo

Lucent 5ESS DRM - A3.2.3 Serial Asynchronous Interface Board Hardware Installation (Netra t 1120)

Default Icon
642 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
d. Wait until all MHDs are fully restored to the ACT state.
Response: RST MHD x COMPLETED
Note: If any MHD cannot be restored, seek technical assistance.
3. Write the AMA data from memory to disk.
a. Enter the following input command:
WRT:AMADATA
Response: WRT AMA DATA HAS BEEN WRITTEN TO DISK
READY TO TRANSFER DATA FROM DISK TO/OUTPUT MEDIUM
4. Isolate the switching module from the AW.
a. Go to the Switching Module Inhibit and Recovery Control Page . Type and
enter command 1800.
b. Set switching module manual isolation. Type and enter 403.
Response: ISOLATE? (Y/N)
c. Type and enter Y to the confirmation.
Response: SET ISOL SM=x COMPLETED
Where: x = The switching module number.
d. If the switching module cannot be isolated, seek technical assistance.
5. Transfer the AMA data from the disk to the output medium, see 235-105-210,
Routine Operations and Maintenance Procedures.
A3.2.3 Serial Asynchronous Interface Board Hardware Installation (
Netra
t 1120)
1. Halt the AW, refer to “Halt the Administrative Workstation,” Procedure 4.2.
2. Remove power to the system unit by locating the power switch and switching it
to off.
3. Detach all cables from the AW System Unit paying particular attention where
each cable attaches. If necessary, label each cable and where it attaches to the
back of the AW System Unit.
Note: The following procedures require the use of the
Sun
Microsystems
SunSAI/P Users Guide and the
Sun
Microsystems
Netra
t 1120/1125 Service
Manual.
4. Add secondary PCI card to PCI Slot 1.
Note: Use the Installing SunSAI/P Boards procedures in the
Sun
Microsystems SunSAI/P Users Guide for reference during this step.
Execute the following steps of the sub-procedure To Replace a PCI Card in the
Sun
Microsystems
Netra
t 1120/1125 Service Manual
Attach a wrist strap
Remove the top access cover (see "Replace a DAT or CD-ROM/DVD Drive
(Netra t 1120)”, Section 4.11 Step 3 and 4 of this document).
Identifying the PCI Slot 1.
Lower the PCI card so that it touches its associated slot on the motherboard.
235-200-150
January 2003
APPENDIX 3
ADMINISTRATIVE WORKSTATION (AW) SERIAL
ASYNCHRONOUS INTERFACE (SunSAI/P) BOARD GROWTH
Issue 3.00 Page A3-3

Table of Contents