Lucent 5ESS DRM User Manual

• From the two upper corners of the card, push the card straight downwards
into the slot until it is fully seated.
• Using a No.2 Phillips-headed screwdriver, insert and tighten the screw
securing the card bracket tab to the system chassis.
• Replace the top access cover.
5. Reattach all existing cables.
6. Attach the new EIA-232 cable to the new PCI card installed in PCI slot 1
7. Attach the new EIA-232 Connector box to the cable attached to PCI slot 1.
8. Restore power to the system unit by locating the power switch and switching it
to on.
A3.2.4 Serial Asynchronous Interface Board Hardware Installation (
Netra 20)
1. Halt the AW, refer to “Halt the Administrative Workstation,” Procedure 4.2.
2. Remove power to the system unit by locating the power switch and switching it
to off.
3. Detach all cables from the AW System Unit paying particular attention where
each cable attaches. If necessary, label each cable and where it attaches to the
back of the AW System Unit.
4. Add secondary PCI card to PCI Slot 1.
Note: Use the Installing SunSAI/P Boards procedures in the
Sun
Microsystems SunSAI/P User’s Guide for reference during this step.
Execute the following steps of the sub-procedure To Replace a PCI Card in the
Sun Microsystems Netra T4 AC100/DC100 Service and System Reference
Manual
• Attach a wrist strap
• Remove the top access cover (see "Replace a DAT or DVD Drive (Netra TM
20)”, Section 4.12 , Step 3 and 4 of this document).
• Identifying the PCI Slot 1.
• Lower the PCI card so that it touches its associated slot on the motherboard.
• From the two upper corners of the card, push the card straight downwards
into the slot until it is fully seated.
• Using a No.2 Phillips-headed screwdriver, insert and tighten the screw
securing the card bracket tab to the system chassis.
• Replace the top access cover.
5. Reattach all existing cables.
6. Attach the new EIA-232 cable to the new PCI card installed in PCI slot 1
7. Attach the new EIA-232 Connector box to the cable attached to PCI slot 1.
8. Restore power to the AW units according to the procedures found in “Restore
Power to Administrative Workstation Units,” Procedure 4.8.
APPENDIX 3
ADMINISTRATIVE WORKSTATION (AW) SERIAL
ASYNCHRONOUS INTERFACE (SunSAI/P) BOARD GROWTH
235-200-150
January 2003
Page A3-4 Issue 3.00

Lucent 5ESS DRM Specifications

General

Brand	Lucent
Model	5ESS DRM
Category	Control Unit
Language	English