When the AW starts to boot, messages similar to those shown in the following
examples are output on the system console:
For Netra t 1120
Resetting ...
screen not found.
Can’t open input device.
Keyboard not present. Using ttya for input and output.
Sun Ultra 60 UPA/PCI (UltraSPARC-II 440 MHz), No keyboard
OpenBoot 3.29, 512 MB memory installed, Serial #13079967
Ethernet address 8:0:20:c7:95:9f, Host ID: 80c7959f.
Initializing Memory
Rebooting with command:
Boot device: /pci@1f,4000/scsi@3/disk@5,0:f File and args:
SunOS Release 5.8 Version Generic-108528-13 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights reserved.
.
.
.
The system is ready.
attaws console login:
For Netra
Resetting ...
Sun Netra T4 (UltraSPARC-III+), No keyboard
Copyright 1998-2002 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.5, 512 MB memory installed, Serial #51344136.
Ethernet address 0:3:ba:f:73:8, Host ID: 830f7308.
Initializing Memory
Rebooting with command:
Boot device: /pci@8,700000/scsi@6/disk@6,0:f File and args:
SunOS Release 5.8 Version Generic-108528-13 64-bit
Copyright 1983-2001 Sun Microsystems, Inc. All rights reserved.
.
.
.
The system is ready.
attaws console login:
The AW will boot and automatically start the AM emulator.
9. Immediately halt the AM emulator using the procedurs outlined in “Halt the
Administrative Module (AM) Emulator,” Procedure 4.1.
A3.2.5 Diagnose New Serial Asynchronous Interface Board Hardware
1. Switch to the UNIX‚ console of the AW by holding down the Ctrl key and
pressing Enter (not Return) on the MCC.
2. If a login prompt does not appear, press Return repeatedly until one appears.
3. At the console prompt, login as root, for example:
attaws console login: root
password: Can be obtained from 5ESS switch TSS.
235-200-150
January 2003
APPENDIX 3
ADMINISTRATIVE WORKSTATION (AW) SERIAL
ASYNCHRONOUS INTERFACE (SunSAI/P) BOARD GROWTH
Issue 3.00 Page A3-5
To Next Page
Loading...
Need help?
General